XiNCOM XC-DPG602 Manuel d'utilisateur télécharger pdf (Page 18)

Load Balance

Figure 7. Load Balance Console

Conﬁguring Load Balancing

The Twin WAN line of products uses a session based Load Balancing algorithm by allowing you to

manage sessions using several different options:

Bytes rx+tx

By monitoring real time speed of both WAN connections, the XC-DPG602 will

establish new sessions on the WAN port with the lower speed. Use this if there is

a fairly even speed on both lines and would like to beneﬁt the most from the speed

available.

Packets rx+tx

Same as above but in this case, the XC-DPG602 monitors the packet ﬂow and tries

to maintain an even number of packets. Use this if transmitting a lot of small packets,

such as web browsing and Usenet. This helps you maintain the best latency.

Sessions

Established

The XC-DPG602 tries to maintain an even number of sessions on each WAN port by

looking at the current amount of sessions currently established. This is a very general

setting only to be used if you have similar types of connections (Cable and Cable, DSL

and DSL) to promote good Internet trafﬁc.

Settings - Load Balance

Load Balance

Conﬁguration

• Enable – Use this to enable your Load Balance settings.

• Balance Type – Select the desired Balance Type:

- Bytes rx+tx – Trafﬁc is measured by Bytes.

- Packets rx+tx – Trafﬁc is measured by Packets.

- Sessions established – Trafﬁc is measured by Sessions.

• Loading Share on WAN 1 – Enter the percentage (%) of trafﬁc to be sent over WAN 1. The WAN port with the greater bandwidth should

be given a higher percentage of trafﬁc over the other WAN port.

Click the “Update” button to save your changes.

NAT Statistics

This section displays the current data about WAN 1 and WAN 2. You can use this information to help you “ﬁne-tune” the settings above.

Interface Statistics

This section displays cumulative statistics.

Use the “Restart Counters” button to restart these counters when required.

Buttons

• Update – Save the settings on this screen.

• Refresh – Update the data on screen.

• Restart Counters – Restart the counters used in the “Interface Statistics” section.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Pas de commentaire

XiNCOM XC-DPG602 Manuel d'utilisateur Page 18